seo68. 1548 posts · Joined 2017. #10 · Dec 4, 2017. Yes, the anti-theft code is defeated by a power reset, but I suspect it is only so because the reset time is so short. The radio probably has some small capacitive power backup that lasts from several minutes to a few hours.
Insert the ignition key and turn it to the on position and then attempt to start the engine (crank over), the engine wont start. With the key still in the run position wait 10 minutes and the security light should blink and then go out. Turn the key off and wait 5 seconds. Repeat these steps for a total for 3, 10 minute cycles.

Certain cars are being stolen using the ODB port. This has been going on for some time with high value vehicles, mainly ones with keyless entry like BMWs and Landrovers. Fiat 500s have been targeted recently. A device that can be purchased from the Interweb which is connected to the ODB port can bypass the ignition and/or code a blank key to

Try disconnecting your battery cables then wait about 10 minutes. The computer should reset itself. Reconnect the wires to the battery. It is normal for the theft light to blink about every 5 seconds when the ignition key is out or in the off position. This means the system is armed and working properly. Use the “ + “ button to input 0 and. press the power button to set. Repeat the process to enter in the full code 000. Once all three. zero’s have been selected, press the power button twice to deactivate the lock. To set your own code, press the “ + “ button and the power button together for 10. seconds. In some vehicles, the anti-theft fuse can be in the fuse box under the hood that’s also on the driver’s side. The fuse box should be behind the air filter. For Ford vehicles, the anti-theft fuse isn’t labeled, so you’ll have to refer to a specific reference number to find it.

Top Answer. Mike E December 28, 2020. To reset the anti-theft on the vehicle You will need to first get into the vehicle and shut the doors. With the doors shut You want to put the key into the ignition slot and turn it on. Once You have turned it on You will then want to turn it back to the off position.

The system should be reset. Insert the key into the driver's side door lock. Turn the key once, but not all the way to unlock the door. Leave the key in this position for 40-60 seconds. Do this again, but turn the key in the opposite direction. Remove the key from the door, get into your Ford, and start the engine. The flashing anti-theft light was telling you the answer. Key. Insert the key into the driver's side door lock. Turn the key once, but not all the way to unlock the door. Leave the key in this position for 40-60 seconds. Do this again, but turn the key in the opposite direction. mTUa5p.
  • 370b0acdz1.pages.dev/718
  • 370b0acdz1.pages.dev/321
  • 370b0acdz1.pages.dev/487
  • 370b0acdz1.pages.dev/967
  • 370b0acdz1.pages.dev/707
  • 370b0acdz1.pages.dev/974
  • 370b0acdz1.pages.dev/938
  • 370b0acdz1.pages.dev/378
  • 370b0acdz1.pages.dev/332
  • 370b0acdz1.pages.dev/164
  • 370b0acdz1.pages.dev/753
  • 370b0acdz1.pages.dev/924
  • 370b0acdz1.pages.dev/636
  • 370b0acdz1.pages.dev/701
  • 370b0acdz1.pages.dev/28

    • fiat 500 anti theft reset