Posted September 20, 2011. On 9/17/2011 at 8:13 AM, fishpond 47 said: I dont think the dash has to come out (well I didnt take mine out), the two lower panels at the sides of the steering wheel have to be removed (screws and clips) to get access to screws holding the clock (s) surround in place then it's a couple of clips holding the top of the
The most common causes for AC fan blower motor not working in Ford Mondeo are blown fuse, bad relay, resistor or control module malfunction and faulty blower motor. However, a bad electrical connector or broken wire, or a defect in the climate control unit can also cause the blower motor to stop working. 1.
Just wen to test it. Worked fine. And I have notes now do my 1.7.1 update is completed. Perhaps my speed sign problem (which started at the same time I got the update message) was a symptom of the update not making its way through all the modules yet. My wife’s car has not received any updates and still has a sign reading problem. (96-00)2.5 V6 Ghia - Instrument Lights not working - lyndy : Wow thanks to the above I have sorted the same problem on my R reg Ford Mondeo, the hardest part was getting the dash section off, a quich spray with WD40 and I am a very happy lady. A garage quoted me £85. Hi all, just got a mondeo and trying to work out what's wrong with the dash boot release, it doesn't work and nor does the tailgate release. Iv done the obvious and checked the switches, they all give good continuity when pressed nd don't seem to be shorting, iv disconnected the tailgate switch as suggested and no dice Re: Ford mondeo dash pinout. « Reply #8 on: April 18, 2011, 08:45:58 pm ». Still no joy finding a pinout for the mk3 dash :- ( even managed to get hold of a Ford TIS disc (technical information system) it's got everything but what I need! it details what colour wire connects to which pin, and a block diagram for the cluster, but nothing that